Peugeot 308 Key Fob Replacement
Peugeot's 308 is a bit old, but it is still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable drive.
We often receive requests from Coded Car Keys to replace peugeot key fobs. Whether the problem is constant or intermittent these tips will assist.
Water Damage
If you accidentally drop your key fob into a puddle, or if it gets wet while kayaking canoeing or rafting or canyoning, the fob is likely to be damaged by water. The best way to stop this from happening is to keep it in a dry, dry bag when you're outside or performing activities in which the fob may be exposed to high levels of water.
It's also important to make sure that the fob is completely dried before you open it to use it again. If you notice any odors coming from the fob, like an industrial-like liquid smell or the scent of windshield washer fluid, it's another sign that it's been submerged in water.
A circuit board that's damp can cause the battery to discharge its charge, or even explode. If you are able to get your keyfob 308 from the water and turn it upside up and shake as much water as you can prior to opening the casing. Once you have opened it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issue, signal interference or a damaged chip. If none of these are the cause, you can try resetting your system by disconnecting the battery with 12 volts for around 15 minutes.
Dead Coin Battery
peugeot 106 key cars are equipped with a remote start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to entering. This feature is extremely beneficial particularly during the cold winter months. Remote start systems may not function due to a variety of reasons, including a dead coin-battery.
A coin-shaped battery that is in the key fob can last for a period of two to four years, depending on how frequently it is used and the location where it was purchased. The date of use will be written on the packaging or mentioned in the user's manual.
If the key fob is no longer functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. In case of exposure to soapy or salty water, the chip could be fried and you will require replacing the key fob entirely.
If you're unsure if the battery is defective it is possible to test the voltage with a multimeter set to your car's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts then you must replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you're not receiving the “Key Detected” message on your dashboard, then it's possible the receiver module has developed a fault. It's the part which sends out a signal when your key fob goes off. It also acts as an alarm and prevents the car from starting without the correct key.
This could be due to a number of causes, such as water damage or simply aging. If your peugeot 208 key fob 308 key fob was exposed to dirty tap water, for example the electronic chip on the inside will be damaged. In this case you will need to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the issue continues to persist you're probably in need of a idea to visit a local Peugeot specialist or locksmith. They will be able to utilize a diagnostic tool to identify the issue and repair it for you.
It is stressful to lose your Peugeot car key. A certified auto locksmith can resolve the issue within minutes. They can program your vehicle and cut a fresh, working key for you. Find locksmiths near you.
Faulty Electronic Chip
The electronic chip in the peugeot 106 key 1007 Key Fob Programming Colonybanjo9.Werite.Net] 308 key fob is a critical function in the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying “anti-theft”. In this instance, the only solution is to replace the key. Professional auto locksmiths are able to offer the service within the shortest possible time.
The chip in your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or other causes. If your Peugeot key fob was exposed to soapy or dirty water, it needs to be cleaned right away. You can clean the electronic component with a paper towel soaked in isopropyl Alcohol. After that, let the battery dry completely.
Radio interference can cause the key fob to stop working. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. It can also be caused by bad weather or objects in the vicinity. It is recommended to see a Peugeot dealer in the event of this issue.
The Peugeot Key Fob 207/308 is delicate and needs special attention. It is important not to drop or throw the key fob. If you lose something, try to locate it as soon as you are able to. You can reset your on-board computer by disconnection of the battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.(Image: https://www.thekeylab.co.uk/wp-content/uploads/sb-instagram-feed-images/311159893_995841588058766_6213964028136182559_nlow.jpg)
