How to Replace a Kia Sportage Replacement Key

(Image: https://www.thekeylab.co.uk/wp-content/uploads/sb-instagram-feed-images/311135906_1281855972636056_2987376612771239945_nlow.jpg)For a number of kia optima car key replacement models keys, there is the keyless entry system that is built into the key. This key is similar to a remote control and can be exchanged with a Kia dealer.

Key fobs can fail to function due to a variety of reasons, including batteries that are dead, worn-out buttons, signal interference or water damage. Here are some suggestions to assist you in getting your Kia key fob that is a replacement for the sportage again.

How do you replace a remote key or a smartkey?

The battery in your Kia's intelligent key will eventually need be replaced, whether it is a remote key that starts with a push button or a regular metal key that is not equipped with an electronic transponder. This is particularly the case if your car displays a message telling you that the smart or remote keys are in poor condition.

It's an easy process. In order to replace the battery of the key fob take the mechanical key from the slit on the back of the key fob. Next, lift the cover. A small screw will be inside the key fob, which holds the battery in the correct position. With a small screwdriver, unscrew the screw and remove the battery that was in place. Then, insert the new one and close the slit inside the key fob.

Test the key fob by pressing the lock and unlock buttons. If the doors lock and unlock exactly as you expect, then you're all set! You can now use kia carens key fob's hands-free lock/unlock function when your fingers are cold or you have to run some errands in Brandon.

Note: Some key fobs may need to be programmed (transponder chips or smart keys). This requires a specific programming machine that only the dealer or locksmith has access to. Other keys (non-transponder metal keys) don't require programming. If your key needs to be reprogrammed, you will need to know the key code number printed on the tag that identifies the key and then record it in a safe place.

How do you replace a battery?

If the Kia key fob doesn't respond when you press the lock/unlock button, it is likely that the battery is insufficient. A low battery may cause other issues, like the check engine light flashing or the engine not cranking correctly. Fortunately replacing the key fob battery is a relatively easy DIY task that requires only some basic tools.

Before beginning the process ensure that your vehicle is off and all doors are shut. Find the small, metal or plastic piece on the bottom of the key fob. Move it until the metal key is released. This key can be placed inside the driver door handle to unlock your car.

To replace the key fob's battery, take off the cover from the back and use a plastic bar tool to remove the latch holding the black negative battery cable. Remove the old battery, and then align the new battery so that the “+” positive side faces you, while the “negative” negative side is facing the fob's metal electrical contacts. Avoid using excessive force when pushing the new CR2032 into position to avoid breaking or bending the steel contacts.

After installing the new battery then turn the key fob on and off in the ignition until the door locks up. You can then test the Kia's Key fob again to make sure it's working as intended.

How do I replace a smart key

Depending on the model of the Kia Sportage, you may have an ordinary key fob for kia fob or a smart key. The difference between the two is that the smart key has a small mechanical key blade that is hidden inside, while the standard fob doesn't. Both types of key fobs are equipped with batteries inside that eventually will need to be replaced. This is a straightforward process that takes just two minutes.

Before you begin it is essential to ensure that you are on a flat surface with sufficient lighting and that the Kia is off. Remember that the fob can contain small pieces that could fall if you're not careful.

The first step is to find the small release button that is located on the back of the lower part of the fob. It's either a circular button or rectangular slot. When you press it the mechanical key blade will be released and you can then open the key fob.

Once you have the key fob open it is easy to remove the old battery, and replace it. The new battery is the CR-2032, and it can be purchased on the internet or at your local auto parts store. After you've finished, your key fob should permit you to lock, unlock, and start your vehicle even if it's not running.

How do I replace the mechanical key

The Kia keyfob is a wonderful convenience that allows us to lock or unlock our car simply by pressing one button. As with all devices like a key fob, the Kia can have issues at times. There are ways to solve these issues and keep your key fobs running for an extended period of time.

One of the most frequent issues is a low or dead battery. This could cause your device to stop working or work intermittently. If this happens try replacing the battery with a fresh new one.

If this does not solve the issue, use a flathead screwdriver standard to push the fob's casing made of plastic open. Be cautious not to damage any internal components or scratch the plastic. Once open, carefully remove the battery you have been using and replace it with a brand new one.

Close and open the door using the mechanical key. (Every kia sportage Smart key fob comes with a spare mechanical key that fits into the slot). Test the key fob to verify that it's working as intended. Contact a dealer or a locksmith to solve the issue in the event that the key fob is not working. To avoid future lockouts, make sure you get an emergency key that will work in all of the door and trunk cylinders.